搅拌上料一体机的高温维修工作_常见问题_自动搅拌一体车_自动搅拌一体机_多功能搅拌车价格-山东山汽工程机械(集团)有限公司

站内搜索

常见问题

热点

自动上料平口搅拌机多种方量可供选择

2022-12-23

混凝土自动上料搅拌车的功能有哪些？

2022-12-19

混凝土自动拌料车移动式可自行走户外施工

2022-12-16

自上料搅拌车企业这么多，买车的时候应该看哪方面？

2022-12-12

关于山汽

联系人：刘老师

电话：400-879-1999

公司：山东山汽工程机械（集团）有限公司

地址：山东省莱州市206国道与308省道交叉口东南50米

搅拌上料一体机的高温维修工作

所属分类：常见问题发布时间：2021-03-29 来源：http://www.shanqijituan.cn/ 浏览量：0

搅拌上料一体机在长期运行过程中会自然升高温度，但是如果温度超过设备本身可以承受的温度，则会对设备造成一定的损害。因此，当设备温度过高时，我们需要对其进行相应的维护工作。让我们来看看。

In the long-term operation process, the mixing and feeding machine will naturally increase the temperature, but if the temperature exceeds the temperature that the equipment can bear, it will cause certain damage to the equipment. Therefore, when the temperature of the equipment is too high, we need to carry out the corresponding maintenance work. Let's see.

1.防止发动机过热：由于环境温度高，发动机容易过热。有必要加强对发动机冷却系统的检查和维护。这包括检查水箱，恒温器，水泵，风扇等，并注意及时添加。注意冷却水。当水温超过100°C时，请停在凉爽的地方冷却下来，让发动机空转，然后打开引擎盖以帮助散热。

1. Prevent the engine from overheating: due to the high ambient temperature, the engine is easy to overheat. It is necessary to strengthen the inspection and maintenance of the engine cooling system. This includes checking the water tank, thermostat, water pump, fan, etc. and adding them in time. Pay attention to the cooling water. When the water temperature exceeds 100 ° C, please stop in a cool place to cool down, let the engine idle, and then open the hood to help heat dissipation.

2.防止发动机爆燃：在夏天，温度很高，有时会超过35°C。在这样的季节，部件部分老化的汽车自然爆燃的可能性更高。因此要做好预防工作。

2. Prevent engine deflagration: in summer, the temperature is very high, sometimes more than 35 ° C. In such a season, the possibility of auto deflagration is higher if the parts are partially aged. Therefore, we should do a good job in prevention.

3.防止汽车漆的损坏：汽车漆暴露在强烈的阳光下会老化和起皱，而普通的美容蜡可以起到一定的防晒作用，但是由于任何汽车蜡中都含有铋，长期的紫外线辐射会导致油漆生锈。留下一个黑点。车蜡本身不能提高硬度和抗紫外线效果，但会因高温而迅速消失。停车时，请将车停在凉爽的地方。

3. Prevent the damage of automobile paint: automobile paint will age and wrinkle when exposed to strong sunlight, and ordinary beauty wax can play a certain role in sunscreen, but because any automobile wax contains bismuth, long-term ultraviolet radiation will cause the paint to rust. Leave a black spot. The car wax itself can not improve the hardness and anti ultraviolet effect, but it will quickly disappear due to high temperature. When parking, please park in a cool place.

4.防止汽车轮胎爆裂：温度高时，容易刺破；温度过高时，轮胎容易变形，抗拉强度降低。由于轮胎本身的气压不是标准的，轮胎老化，性能减弱或在行驶过程中轮胎滚动成硬质金属或其他硬物，会导致汽车突然爆裂。

4. Prevent tire burst: when the temperature is high, it is easy to puncture; when the temperature is too high, the tire is easy to deform and the tensile strength is reduced. Because the air pressure of the tire itself is not standard, the tire will be aging, the performance will be weakened or the tire will roll into hard metal or other hard objects during driving, which will cause the car to burst suddenly.

5.防止发动机润滑不良：温度高时，机油粘度降低，导致润滑不良。因此，请务必检查机油的质量并及时添加或更换。注意及时清洁机油滤清器和散热器，以确保机油平稳流动和良好的散热，并尽量避免发动机过载。

5. Prevent poor lubrication of the engine: when the temperature is high, the viscosity of the engine oil decreases, resulting in poor lubrication. Therefore, be sure to check the quality of the oil and add or replace it in time. Pay attention to clean the oil filter and radiator in time to ensure the smooth flow of oil and good heat dissipation, and try to avoid engine overload.

6.防止制动故障：在高温环境下，制动液更容易蒸发和汽化，在制动管中形成空气阻力，制动蹄也容易烧蚀，从而导致制动故障。因此，需要经常检查和调整制动系统。在长斜坡上，应注意驻车制动器，以确保良好的制动性能。如果发现制动轮毂很热，请将其停止并冷却。

6. Prevent brake failure: in high temperature environment, the brake fluid is more likely to evaporate and vaporize, forming air resistance in the brake pipe, and the brake shoes are also easy to be ablated, resulting in brake failure. Therefore, it is necessary to check and adjust the braking system frequently. On long slopes, pay attention to the parking brake to ensure good braking performance. If the brake hub is found to be hot, stop it and cool it.

我相信每个人都知道在三点钟和七点钟维护时会使用任何机械设备。只有这样，才能保证设备在正常运行中的良好性能，才能延长设备的使用寿命。希望每个人都能了解这些知识，合理使用设备。

I'm sure everyone knows that any mechanical equipment will be used for maintenance at three and seven o'clock. Only in this way can we ensure the good performance of the equipment in normal operation and extend the service life of the equipment. I hope everyone can understand this knowledge and use the equipment reasonably.

上一页：自动搅拌一体车如何进流搅拌？下一页：多功能搅拌车电控换挡保护系统设计

热门产品 / HOT PRODUCT