When unloading each time, please use the tank car to move the water gun to the notch, blade, water inlet, tank body and corner to stop flushing and prevent post melting concrete deposits. Cleaning is not easy. After pouring more than 1 cubic meter of pure water into the water tank, the main body of the water tank rotating on the ground will stop cleaning. In the process of operation, it can be cleaned at any time, and it can be cleaned thoroughly after stopping the tanker.
Water supply process of mixer truck: control the air pressure and fix the joint. The tank pressure is set at the factory. You don't have to adjust yourself. If self-regulation is required under special circumstances, it is recommended to control the air pressure at 3.5Mpa.
Due to different raw materials, the specific quality of each pallet is slightly different. When loading concrete, please carefully check the slump and connection, and pay attention to the premature melting and delamination of concrete to prevent it from being transported to the site. It cannot be used, it destroys labor and material resources. Pay attention to the transport distance, which may change the specific performance. We recommend that the diameter of this distance be kept within 30 km.
Before leaving the vehicle, please plan the traffic condition of the mixer. However, this only increases the travel time of the vehicle on the road. Whenever you encounter artificial or irresistible elements that cannot be discharged, please check the condition of the tank. After the concrete begins to melt, the material shall be drained immediately to avoid damaging the whole storage tank.
The above is the auto mixer manufacturers to introduce the relevant content, hope to help you, more exciting content can be directly concerned about: http://www.shanqijituan.cn