自动上料水泥搅拌车密封条怎样维护？ - 行业动态_新闻资讯-山东山汽工程机械(集团)有限公司

站内搜索

新闻资讯

公司新闻行业动态

热点推荐

自动上料平口搅拌机多种方量可供选择

2022-12-23

混凝土自动上料搅拌车的功能有哪些？

2022-12-19

混凝土自动拌料车移动式可自行走户外施工

2022-12-16

自上料搅拌车品牌这么多，买车的时候应该看哪方面？

2022-12-12

关于山汽

联系人：刘老师

电话：400-879-1999

公司：山东山汽工程机械（集团）有限公司

地址：山东省莱州市206国道与308省道交叉口东南50米

自动上料水泥搅拌车密封条怎样维护？

所属分类：行业动态发布时间：2022-11-04 来源：http://www.shanqijituan.cn/ 浏览量：18

1、检查自动上料水泥搅拌车密封是否有大的裂缝。如果密封破损，可以用粘合剂修复。特别是，通过使用特殊的粘合剂进行密封，很容易填充大的裂缝带。当然，如果密封件严重损坏或老化，请更换新密封件。

1. Check whether there are large cracks in the seal of the automatic feeding cement mixer. If the seal is damaged, it can be repaired with adhesive. In particular, large crack zones can be easily filled by sealing with a special adhesive. Of course, if the seal is seriously damaged or aged, please replace it with a new one.

2、用混凝土搅拌清洗剂清洗门窗密封后，驱动器涂上一层渗透保护剂，防止密封条老化，大大提高密封条的密封性能。除此之外，挡风雨条之间的间隙很容易被灰尘和铁锈填满。为此，请使用刷子清除灰尘。

2. After the doors and windows are cleaned with concrete mixing cleaning agent, the driver is coated with a layer of penetration protection agent to prevent the aging of the sealing strip and greatly improve the sealing performance of the sealing strip. In addition, the gap between weather strips is easily filled with dust and rust. To do this, use a brush to remove the dust.

3、更换整个机身时，应在焊缝重叠处涂上一层密封胶。粘合剂层的厚度应为约1mm，并且粘合剂层不应具有诸如假粘性和气泡。地板的整个下表面和前轮罩的下表面应涂有3mm-4mm的弹性涂层和防腐涂层。这些措施不仅大大提高了车辆的密封性能，减缓了车身的锈蚀速度，还大大提高了乘坐舒服性。

3. When replacing the whole machine body, a layer of sealant shall be applied to the weld overlap. The thickness of the adhesive layer shall be about 1mm, and the adhesive layer shall not have such false stickiness and bubbles. The whole lower surface of the floor and the lower surface of the front wheel housing shall be coated with 3mm~4mm elastic coating and anti-corrosion coating. These measures not only greatly improve the sealing performance of the vehicle, slow down the corrosion rate of the body, but also greatly improve the ride comfort.

4、门和车身的密封是相对困难的部分。密封要求相对严格。待密封的部分相对较长，每个密封部分的横截面形状不同，并且门经常打开和关闭。在自动搅拌车上安装三通四通密封件，并安装前支柱和顶梁侧梁的四个密封结构。这种多通道密封件通常放置在前门缝中，除了密封功能外，还具有降低汽车噪音的效果。

4. Sealing the door and body is a relatively difficult part. The sealing requirements are relatively strict. The part to be sealed is relatively long, the cross section shape of each sealing part is different, and the door is often opened and closed. Install the three-way and four-way seals on the automatic mixer truck, and install the four sealing structures of the front pillar and the top beam side beam. This multi-channel seal is usually placed in the front door seam. In addition to the sealing function, it also has the effect of reducing vehicle noise.

5、车窗玻璃损坏后，驾驶员在更换玻璃时应检查密封是否损坏。由于窗户经常在修理后不能恢复到原来的形状，除了确保窗玻璃可以容易地拉动或抬起之外，还须注意窗户玻璃周围的密封。如果玻璃与玻璃槽之间的间隙不均匀，则橡胶条与玻璃和玻璃槽接触不好，驾驶员可以用手轻松拉动密封圈。

5. After the window glass is damaged, the driver should check whether the seal is damaged when replacing the glass. Since the window cannot be restored to its original shape after repair, in addition to ensuring that the window glass can be easily pulled or lifted, attention should also be paid to the sealing around the window glass. If the gap between the glass and the glass groove is uneven, the rubber strip will not contact the glass and the glass groove well, and the driver can easily pull the sealing ring with his hand.

6、更换车顶时，驾驶员应首先在车顶周围涂一层导电密封胶。将卷边胶涂在转轮和接头上。这不仅有助于身体。密封可防止由于法兰焊缝中积水造成的汽车早期腐蚀。

6. When replacing the roof, the driver should first apply a layer of conductive sealant around the roof. Apply the curling adhesive to the runner and joint. This not only helps the body. The seal can prevent the early corrosion of the vehicle caused by water accumulated in the flange weld.

7、自动上料水泥搅拌车天窗是大多数家用轿车的基本配置。当汽车的天窗打开时，橡胶密封的导轨暴露在空气中，不可避免地积聚灰尘，甚至进入小砾石。长时间使用可能会导致天窗因磨损而变形并堵塞排水孔。因此，定期清洁导轨并在导轨上涂抹润滑剂非常重要。

7. The skylight of automatic feeding cement mixer is the basic configuration of most family cars. When the sunroof of the car is opened, the rubber sealed guide rail is exposed to the air, which inevitably accumulates dust, even into small gravel. Prolonged use may cause the sunroof to deform due to wear and block the drain hole. Therefore, it is very important to clean the guide rail regularly and apply lubricant to the guide rail.

以上就是为大家介绍的有关多功能搅拌车的详细的介绍,希望对您有所帮助.如果您有什么疑问的话,欢迎联系我们.我们将以的态度,为您提供服务http://www.shanqijituan.cn/

The above is a detailed introduction to the multi-function mixer, and I hope it will be helpful to you. If you have any questions, please contact us. We will provide services for you with our attitude http://www.shanqijituan.cn/

上一页：小型混凝土搅拌车出车时遇到这些问题了吗？下一页：自动上料水泥搅拌车漏油怎么办？

热门产品 / HOT PRODUCT