In order to prolong the service life of the automatic mixer, it is necessary to carry out regular maintenance of the automatic mixer. For maintenance, many car owners know the role of maintenance. However, there are not many automatic mixers. Sometimes the owners will miss something during the maintenance. In order to make the use of automatic mixers better, every part should be maintained.
It is used to generate electricity in the work of the car. It drives the generator to rotate through the rotation of the engine of the automatic mixer car. After generating current, it is used by other parts of the automatic mixer car. Although the generator is a passive device, theoretically the loss is less than other parts, but for the rotating bearing and pulley of the automatic mixer, it is also the place where the generator is vulnerable to wear.
It is recommended to check the belt tightness of the automatic mixer and maintain the generator reasonably.
2. Ignition wire
As we all know, some drivers will change the spark plug themselves, but compared with it, the ignition wire is rarely concerned. Some drivers said: why is there nothing wrong with their car, but they just don't like fire? The fuel consumption of driving becomes higher and the power is poor, if it is not caused by other reasons.
The driver is advised to check the ignition line. It is recommended to replace the ignition wire every 20000 km
3. Brake disc
It is believed that everyone should be familiar with the brake disc of the mixer. At present, more and more automatic mixers are gradually over equipped with the brake from the front disc to the rear drum. The advantage of using disc brake is that it has better heat dissipation, and it is more convenient to clean and replace. Most drivers think that the brake pad is easier to wear than the brake disc. They don't pay enough attention to the brake disc. In fact, the force between the disc and the pad is mutual, and the contact friction will wear. Moreover, the surface of the brake disc is smoother than the brake pad, and it is easy to be affected by the rough surface of the brake pad. The brake pad itself is a vulnerable part, but when we check and replace the brake pad, we should also pay attention to the condition of the brake disc surface of the mixer, if there are relatively clear scratches.
It is recommended to replace the brake disc with a new one to avoid unintended consequences