随着市场的多样化,市场上现有的自动上料混合设备的质量不均衡。对于许多商家来说,购买设备也存在一定的困难。因此,我将教你一些区分自动搅拌一体机质量的方法。
With the diversification of the market, the quality of the existing automatic feeding mixing equipment is not balanced. For many businesses, there are some difficulties in purchasing equipment. Therefore, I will teach you some ways to distinguish the quality of automatic mixer.
1.自动搅拌一体机材料对其质量的影响不容忽视。良好的材料在使用时具有一定的耐腐蚀性,耐压性和小的阻力。
1. The influence of materials on the quality of automatic mixer can not be ignored. Good material in use has a certain degree of corrosion resistance, pressure resistance and small resistance.
2.除材料外,还一定遵守自动上料搅拌车过滤器的端盖与金属之间的接触。
2. In addition to the materials, the contact between the end cover of the automatic feeding mixer filter and the metal must be observed.
3.在购买过程中,有必要了解搅拌一体机的过滤元件是否可以回收,是否可以用水冲洗等,其使用寿命和使用寿命需要有一定的了解。
3. In the purchase process, it is necessary to know whether the filter elements of the mixer can be recycled, whether it can be washed with water, etc., and its service life and service life need to have a certain understanding.
我相信在了解了这些知识之后,我们还可以看到过滤器和滤芯对自动送料混合器质量的影响是重要的。因此,在采购过程中,您必 须充分了解其质量。它可以保证设备在使用过程中的正常性能和效果。
I believe that after understanding this knowledge, we can also see that the influence of filter and filter element on the quality of automatic feeding mixer is important. Therefore, in the purchasing process, you must fully understand its quality. It can ensure the normal performance and effect of the equipment in use.
自动搅拌一体机的安 全程序
Safety program of automatic mixer
1.在驾驶之前,您一定仔细检查车辆的状况,以确保车辆能够安 全驾驶。
1. Before driving, you must carefully check the condition of the vehicle to ensure that the vehicle can drive safely.
2.当搅拌一体机停放在露天时,搅拌桶应在装料前翻转,并应排出积聚的水和碎屑,以确保混凝土的质量。
2. When the mixer is parked in the open air, the mixing bucket shall be turned over before loading, and the accumulated water and debris shall be discharged to ensure the quality of concrete.
3.运输混凝土时,确保倾斜槽牢固放置,防止因松动而摆动,行人在行驶中受伤或影响其他车辆的正常运行,同时注意避免混凝土溢出和污染地面。
3. When transporting concrete, ensure that the inclined slot is firmly placed to prevent swinging due to looseness, pedestrian injury during driving or affecting the normal operation of other vehicles, and pay attention to avoid concrete overflow and ground pollution.
4.搅拌机不应运输混凝土超过搅拌站规定的时间。在运输混凝土的途中,搅拌筒不应长时间停止,以防止混凝土的分离。驾驶员应始终注意具体情况,并在发现异常时通知主控室,并申请。
4. The mixer shall not transport the concrete beyond the time specified by the mixing plant. During the transportation of concrete, the mixing drum should not be stopped for a long time to prevent the separation of concrete. The driver should always pay attention to the specific situation and inform the main control room when finding any abnormality and apply for treatment.
5.当混凝土安装在车内时,现场的停滞时间不得超过1小时。如果超时,应要求现场负责人及时处理。
5. When the concrete is installed in the vehicle, the dead time on site shall not exceed 1 hour. In case of overtime, the person in charge of the site shall be required to deal with it in time.
6.当自动上料搅拌车通过非泵运输时,应从混凝土排放到油箱。温度高时,不得超过2小时。如果超过2小时,一定将其排出。在阴雨天气温度较低时,不应超过2.5小时。
6. When the automatic feeding mixer is transported by non pump, the concrete shall be discharged to the oil tank. When the temperature is high, it shall not exceed 2 hours. If more than 2 hours, it must be discharged. When the temperature is low in rainy weather, it should not exceed 2.5 hours.
7.在排出混凝土之前,搅拌筒应以10-12rpm的速度旋转1分钟,然后排出。
7. Before discharging the concrete, the mixing drum shall be rotated at a speed of 10-12rpm for 1 minute, and then discharged.
8.当自动搅拌一体机完成后,应将水从车辆的软管中排出,并应将进料口,卸料斗和卸料槽冲洗并排干,以去除粘附在车身上的污垢和残留混凝土。保持车辆卫生。
8. After the completion of the automatic mixer, the water shall be discharged from the hose of the vehicle, and the inlet, discharge hopper and discharge groove shall be washed and drained to remove the dirt and residual concrete adhered to the vehicle body. Keep the vehicle clean.