自动上料搅拌一体机加润滑剂时应该注意什么呢？_公司新闻_新闻资讯_自动搅拌一体车_自动搅拌一体机

站内搜索

新闻资讯

公司新闻行业动态

热点

自动上料平口搅拌机多种方量可供选择

2022-12-23

混凝土自动上料搅拌车的功能有哪些？

2022-12-19

混凝土自动拌料车移动式可自行走户外施工

2022-12-16

自上料搅拌车企业这么多，买车的时候应该看哪方面？

2022-12-12

关于山汽

联系人：刘老师

电话：400-879-1999

公司：山东山汽工程机械（集团）有限公司

地址：山东省莱州市206国道与308省道交叉口东南50米

自动上料搅拌一体机加润滑剂时应该注意什么呢？

所属分类：公司新闻发布时间：2020-09-14 来源：http://www.shanqijituan.cn/ 浏览量：0

自动上料搅拌一体机这种机械设备需要不时进行润滑，以便在长期使用时保持良好的操作性能。那么在为设备添加润滑剂时应该注意什么呢？

This kind of mechanical equipment needs lubrication from time to time in order to maintain good operation performance in long-term use. So what should be paid attention to when adding lubricant to the equipment?

1.自动上料搅拌一体机在运行过程中不应进行修理和润滑。

1. The automatic feeding and mixing machine should not be repaired and lubricated during operation.

2.定期在每个润滑脂嘴上添加黄油，并在轴端密封处每4小时润滑一次油，每周排水一次。

2. Regularly add grease to each grease fitting, lubricate the shaft end seal every 4 hours, and drain water once a week.

3.使用自动上料搅拌一体机后，根据需要在每个润滑点添加必要的润滑油（滚筒轴，滚筒，钢丝绳和其他有效部件）。

3. After using the automatic feeding and mixing machine, add necessary lubricating oil (drum shaft, drum, wire rope and other effective parts) at each lubricating point as required.

4.自动上料搅拌一体机减速机的齿轮和轴承使用齿轮旋转将油溅入油箱内壁并流入轴承进行润滑。变速箱的油位应保持在油量计的两条线之间。油位过高或过低都会导致各部件温度升高或润滑不良，增加动力损失并导致机器运行不良。

4. The gears and bearings of the reducer of the automatic feeding and mixing machine splash oil into the inner wall of the oil tank and flow into the bearing for lubrication. The oil level of the gearbox should be maintained between the two lines of the oil gauge. If the oil level is too high or too low, the temperature of each part will rise or the lubrication will be poor, which will increase the power loss and lead to the poor operation of the machine.

5.自动送料搅拌机选用的润滑油应具有一定的粘度和粘温特性，低凝固点，良好的氧化稳定性，无机械杂质和水分，无腐蚀和耐磨材料。其质量指标应符合标准。

5. The lubricating oil selected by the automatic feeding mixer should have certain viscosity and viscosity temperature characteristics, low freezing point, good oxidation stability, no mechanical impurities and moisture, no corrosion and wear-resistant materials. The quality index should meet the national standard.

上料搅拌一体机用于润滑，减少磨损，提高部件的使用寿命。但是，在添加润滑油的过程中需要注意一些事项。新机器应在初150小时和300小时内更换一次，以测试期间未完全清洁的污垢。工作时，请务必检查油位，并及时添加。

The feeding and mixing machine is used for lubrication, reducing wear and improving the service life of components. However, in the process of adding lubricating oil, we need to pay attention to some matters. The new machine should be replaced once in the first 150 hours and 300 hours to remove dirt that was not completely cleaned during the test. When working, please check the oil level and add it in time.

自动上料搅拌一体机关于添加润滑油的问题就是这样了，希望对你有帮助。如有更多疑问可以关注公司网站:http://www.shanqijituan.cn后续会有更多的内容呈现。

Automatic feeding and mixing machine about the problem of adding lubricating oil is like this, hope to help you. For more questions, please visit the company's website: http://www.shanqijituan.cn More content will be presented later.

上一页：自动搅拌一体车维修油耗降低的方法下一页：购买多功能搅拌机的这些你都看好了吗？

热门产品 / HOT PRODUCT