科学生产一直是各个企业放在前位的大事,如何科学的操作自动搅拌车也是很重要的,今天,小编就带大家一起来学习一下。
Scientific production has always been the top priority for all enterprises. How to operate the automatic feeding mixer scientifically is also very important. Today, Xiaobian will take you to learn it.
自动搅拌车装运搅拌好的混凝土时,搅拌筒转速为2-10转/分,在运送过程中,平整路面上搅拌筒转速保证在2-3转/分,行进在侧倾斜度大于50的路面,或摆布晃动较大的路面时,应中止搅拌旋转,待路况好转后再搅拌旋转。起动之前,应把搅拌筒操作手柄放在“中止”方位。起动发动机后,应使搅拌筒在低速下滚动10分钟左右,使液压油温升到20℃以上后方可作业。
When the automatic mixer truck is used to transport the mixed concrete, the speed of the mixing drum shall be 2-10 rpm. During the transportation, the rotation speed of the mixing drum shall be kept at 2-3 rpm on the flat road surface. When the truck is traveling on the road with a side slope greater than 50 or swinging the road surface with large shaking, the mixing rotation shall be stopped and the mixing rotation shall be conducted after the road conditions are improved. Before starting, put the mixing drum operating handle in the "stop" position. After starting the engine, the mixing drum should be rolled at low speed for about 10 minutes, and the hydraulic oil temperature can be increased to above 20 ℃.
车内装有混凝土时,在现场不得停留超越1小时,如超时应立即请求现场负责人给予及时处理。自动上料搅拌车运送混凝土塌落度不得低于8cm。从混凝土入罐到排出,气温高时不得超越2小时,阴雨气候温度低时,不得超越2.5小时。运送混凝土途中,搅拌筒不得长时间停转,以防混凝土发生离析现象。司机应经常调查混凝土状况,发现异常及时通报调度室,请求做出处理。
When the vehicle is filled with concrete, it is not allowed to stay at the site for more than 1 hour. If it exceeds the time limit, the person in charge of the site shall be asked to deal with it in time. The slump of concrete transported by automatic loading mixer shall not be less than 8cm. From the concrete entering the tank to discharging, it shall not exceed 2 hours when the temperature is high, and it shall not exceed 2.5 hours when the temperature is low in rainy climate. During the transportation of concrete, the mixing drum shall not be stopped for a long time to prevent concrete segregation. The driver shall often investigate the concrete condition, report to the control room in time if any abnormality is found, and request to deal with it.
自动搅拌车在露天停放时,装料前应将搅拌筒回转,将积水和杂物排出,以保证混凝土的质量。在运送混凝土时,要保证滑斗放置结实,防止因松动形成摇摆,在跋涉中打伤行人或影响其它车辆正常运转。出料结束,应立即用随车的软管放水将进料口、出料斗及出料溜槽等部位冲洗干净,再向搅拌筒内灌150-200L的清水,让搅拌筒慢速滚动,以清洗内壁。
When the automatic mixer truck is parked in the open air, the mixing drum should be rotated before loading to discharge water and debris, so as to ensure the quality of concrete. When transporting concrete, it is necessary to ensure that the sliding bucket is placed firmly to prevent swing due to looseness, which may injure pedestrians or affect the normal operation of other vehicles. At the end of discharging, immediately flush the inlet, discharge hopper and discharge chute with hose on the truck, and then fill 150-200l of clean water into the mixing drum to let the mixing drum roll slowly to clean the inner wall.