搅拌车的定期维护需要维护什么？_公司新闻_新闻资讯_自动搅拌一体车_自动搅拌一体机

站内搜索

新闻资讯

公司新闻行业动态

热点

自动上料平口搅拌机多种方量可供选择

2022-12-23

混凝土自动上料搅拌车的功能有哪些？

2022-12-19

混凝土自动拌料车移动式可自行走户外施工

2022-12-16

自上料搅拌车企业这么多，买车的时候应该看哪方面？

2022-12-12

关于山汽

联系人：刘老师

电话：400-879-1999

公司：山东山汽工程机械（集团）有限公司

地址：山东省莱州市206国道与308省道交叉口东南50米

搅拌车的定期维护需要维护什么？

所属分类：公司新闻发布时间：2022-05-09 来源：http://www.shanqijituan.cn/ 浏览量：0

多搅拌车门以及焊接和焊接实际上是用密封条胶粘的。这也是确保密封的操作。否则，这些缝隙很容易被外界的风或沙填充，从而引起腐蚀等。令人不快的景象。今天，我想与您分享密封条的日常维护。

The multi stirring door and welding and welding are actually glued with sealing strips. This is also the operation to ensure sealing. Otherwise, these gaps are easy to be filled by external wind or sand, resulting in corrosion, etc. An unpleasant sight. Today, I want to share with you the routine maintenance of the sealing strip.

1.检查自动上料搅拌车的密封件是否有大的裂缝或裂缝。如果密封破裂，可以用粘合剂修好。特别是，在密封件上使用***粘合剂可以轻松填充较大的裂缝区域。当然，如果密封件严重损坏或损坏，请更换密封件。

1. Check whether there are large cracks or cracks on the seals of the automatic feeding mixer. If the seal breaks, it can be repaired with adhesive. In particular, the use of * * * adhesive on the seal can easily fill large crack areas. Of course, if the seal is seriously damaged or damaged, replace the seal.

2.在驾驶员用混凝土混合清洁剂清洁门窗密封条之后，应涂一层渗进防护剂，以防止密封条老化，并显着提高密封条的密封性能。另外，密封条之间的间隙容易充满灰尘和锈蚀。为此，您需要使用刷子除去灰尘。

2. After the driver cleans the door and window sealing strip with concrete mixed detergent, a layer of penetrating protective agent shall be applied to prevent the sealing strip from aging and significantly improve the sealing performance of the sealing strip. In addition, the gap between sealing strips is easy to be filled with dust and rust. To do this, you need to use a brush to remove dust.

3.更换整个机身时，有必要在焊接部分的重叠部分涂一层密封剂。粘合剂层的厚度约为1mm，并且粘合剂层没有不适当的粘合，气泡和其他缺陷。地板的整个底面和前轮盖的底面应涂3mm-4mm的弹性涂层和防腐涂层。这些措施不仅显着提高了车身的密封性能，减缓了车身的腐蚀速度，而且大大提高了乘坐舒服程度。

3. When replacing the whole fuselage, it is necessary to apply a layer of sealant on the overlapping part of the welding part. The thickness of the adhesive layer is about 1mm, and the adhesive layer is free from improper bonding, bubbles and other defects. The entire bottom surface of the floor and the bottom surface of the front wheel cover shall be coated with 3mm-4mm elastic coating and anti-corrosion coating. These measures not only significantly improve the sealing performance of the body, slow down the corrosion rate of the body, but also greatly improve the ride comfort.

4.密封门和门是一个相对困难的部分。密封要求相对严格。要密封的部分相对较长，要密封的部分的横截面形状不相同，并且门经常被打开和关闭。在混凝土搅拌车上安装3向和4向密封垫，并安装前支柱和顶梁侧梁的4密封结构。这种类型的多通道密封通常放置在前门之间的间隙中，除了具有密封功能外，还具有减少车辆噪音的作用。

4. Sealing doors and doors is a relatively difficult part. The sealing requirements are relatively strict. The part to be sealed is relatively long, the cross-sectional shape of the part to be sealed is different, and the door is often opened and closed. Install 3-way and 4-way gaskets on the concrete mixer, and install the 4-way sealing structure of the front pillar and top beam side beam. This type of multi-channel seal is usually placed in the gap between the front doors. In addition to the sealing function, it also reduces vehicle noise.

5.车窗玻璃损坏后，驾驶员应在更换玻璃时检查密封条是否损坏。除了能够轻松地拉起和提起车窗玻璃外，还应注意车窗玻璃周围的密封，因为维修后车窗通常不会恢复其原始形状。如果玻璃与玻璃罐之间的间隙不均匀，则橡胶条在玻璃与玻璃罐之间的接触不良，驱动器很容易用手拉动密封圈。

5. After the window glass is damaged, the driver should check whether the sealing strip is damaged when replacing the glass. In addition to being able to easily pull up and lift the window glass, attention should also be paid to the sealing around the window glass, because the window will not return to its original shape after maintenance. If the gap between the glass and the glass can is uneven, the rubber strip has poor contact between the glass and the glass can, and the driver can easily pull the sealing ring by hand.

6.更换车顶时，驾驶员需要先压装并在车顶周围涂上一层导电密封胶。焊接后，在流道和接头上涂卷边胶。这不仅有助于身体。密封件可以防止因法兰焊缝中积水而引起的过早腐蚀。

6. When replacing the roof, the driver needs to press fit and apply a layer of conductive sealant around the roof. After welding, apply crimping glue on the flow channel and joint. This not only helps the body. The seal can prevent premature corrosion caused by ponding in the flange weld.

7.自动上料搅拌车的天窗是大多数家庭用车的基本配置。当您打开汽车的天窗时，橡胶密封导轨会暴露在空气中，这不可避免地会积聚灰尘，甚会进入小砾石中。长期使用后，天窗可能会因磨损而变形，排水口可能会堵塞。

7. The skylight of automatic loading mixer truck is the basic configuration of most family cars. When you open the sunroof of the car, the rubber seal guide rail will be exposed to the air, which will inevitably accumulate dust and even enter the small gravel. After long-term use, the sunroof may be deformed due to wear and the drain may be blocked.

密封条只是机身的一小部分，但它可以确保门的稳定性和重量，保护内部免受风，雨，灰尘，热量和噪音的影响，并可以装饰门的边缘和窗户。当车身振动或扭曲时，密封条还可以用作减震器和减震器以保护玻璃。因此，混凝土搅拌车的维护不是一件容易的事，并且连接也不容忽视。

The sealing strip is only a small part of the fuselage, but it can ensure the stability and weight of the door, protect the interior from wind, rain, dust, heat and noise, and decorate the edges of the door and windows. When the body vibrates or distorts, the sealing strip can also be used as a shock absorber and shock absorber to protect the glass. Therefore, the maintenance of concrete mixer truck is not an easy task, and the connection can not be ignored.

上一页：让混凝土搅拌车车轮耐用的技巧下一页：如何预防小型混凝土搅拌车汽缸破裂？

热门产品 / HOT PRODUCT