自动搅拌一体车能对混凝土进行快速的搅拌,节省了大量的人力物力,因此成为了工地上不能缺少的机器,为了能够物尽其用,全自动上料搅拌一体车价格,使用者还需要掌握一些关于搅拌车的各方面知识,今天小编就给大家简单介绍一下自动搅拌一体车清理土渣的两种方法吧。
The automatic mixer truck can quickly mix concrete, saving a lot of manpower and material resources, so it has become an indispensable machine on the construction site. In order to make the best use of the materials, the price of the fully automatic feeding mixer truck, the user still needs to master some knowledge about the mixer truck. Today, I will give you a brief introduction of the automatic mixer truck cleaning soil slag Two ways.
搅拌车清洗土渣的方法一:
The first method for cleaning soil residue with mixer truck is as follows:
1.准备好紧急驱动软管,将搅拌车熄火,卸下液压马达上的高压油管接头。
1. Prepare the emergency drive hose, turn off the mixer, and remove the high-pressure oil pipe connector on the hydraulic motor.
2.将自上料混凝土搅拌车熄火,将其液压马达的高压油管卸下,并与故障车上的对应接头用紧急驱动软管相连。
2. Turn off the self feeding concrete mixer, remove the high-pressure oil pipe of its hydraulic motor, and connect it with the corresponding joint on the fault truck with emergency drive hose.
3.发动搅拌车,将其---手柄拨出料位置,故障车内的混凝土即被排出。
3. Start the mixer truck, turn its handle to the discharging position, and the concrete in the fault truck will be discharged.
4.紧急驱动完毕后,全自动上料搅拌一体车,将驱动软管卸下,并恢复两车原状。
4. After the emergency drive is completed, the full-automatic feeding and mixing vehicle will unload the driving hose and restore the original state of the two vehicles.
自自动搅拌一体车清洗土渣的方法二:
The second method is to clean the soil residue with the automatic mixer
托轮和滚道之间放入木楔,以控制搅拌筒的旋转,一定要注意;将发动机熄火,拆松液压马达的一根高压油管,搅拌筒可自由旋转,全自动上料搅拌一体车,控制搅拌筒的旋转,使维修孔转到下部,然后打开维修孔,清理出筒内混凝土,此时一定要注意,混凝土排出完毕后,恢复搅拌车原状。
A wooden wedge is placed between the supporting roller and the raceway to control the rotation of the mixing drum; Turn off the engine and loosen a high-pressure oil pipe of the hydraulic motor. The mixing drum can rotate freely. The full-automatic feeding and mixing truck controls the rotation of the mixing drum to make the maintenance hole turn to the lower part, and then open the maintenance hole to clean out the concrete in the cylinder. At this time, pay attention to safety. After the concrete is discharged, restore the mixer truck to its original state.